GBC StreamPunch Ultra Service Manual page 27

Chip Tray Full
The Chip Tray full message is displayed when the punch chips fill the chip
tray and the capacity is exceeded.
1. Remove the Chip tray and empty the punch chips.
This clears the fault.
Yes- Return to normal operation
2. Clean the Chip Level Emitter and Chip Level Receiver Sensors
(PL 2.5). Ensure the sensor path is clear with the Chip Tray installed.
The Chip Level Emitter and Receiver Sensors are located in the Chip
Tray cavity in the lower portion of the front frame. See ARP 3.3 and
3.4 for more details.
This clears the fault
Yes- Retun to normal operation
3. Remove the Chip Tray and check if the Chip level Emitter and Chip
level Receiver are plugged in.
The Chip level emitter and receiver are located in the Chip tray cavity
in the lower portion of the front frame. See ARP 3.3 and ARP 3.4 for
more details.
See the Sensor Cables table on page 2-35 for cable numbers.
The connections are good.
Yes- Do ARP 1.6 to remove the Rear Cover and go to Step 4.
No- Make the connection and return to normal operation.
4. Check if Cable 7715485 is connected to J27 at the Main Control
Board (Section 7 Wiring).
The connection is good.
Yes- Go to Step 5
No-
Make the connection and return to normal operation.
5. Do GP 6.2.12 Firmware Upgrade procedure to re-flash the Firmware
for Advanced Punch Pro,
Re-flashing the firmware clears the fault.
Yes- Return to normal operation
GBC StreamPunch Ultra/Ultra MP
No- Go to Step 2
No- Go to Step 3
No- Go to Step 6
6. Do ARP 3.3 to Replace the Chip Level Emitter (PL 2.5).
This clears the fault
Yes- Return to normal operation
7. Do ARP 3.3 to Replace the Chip Level Receiver (PL 2.5).
This clears the fault.
Yes- Return to normal operation
8. Replace cable 7715485 (Section 7 Wiring)
This clears the fault.
Yes- Return to normal operation
No- Do ARP 5.1 to Replace the Main Control Board (PL 6.1).
11-05-2018
2-10
No- Go to Step 7
No- Go to Step 8.
RTPS