Arp 3.1.2 Punch Module Installation - GBC StreamPunch Ultra Service Manual

•
Place the Punch Module on a flat surface.
GBC StreamPunch Ultra/Ultra MP
ARP 3.1.2 Punch Module Installation
Use this procedure to install the Punch Module.
1. Slide the Punch Module into the slot at the rear of the machine.
2. Install the punch module lock plates and tighten the captive screws.
3. Connect all electrical connectors for the below 10 components.
•
Connector for Punch Motor M10.
•
Connector for Sensors S16 and S17.
•
Die Set Recognition Connector (2 terminals)
•
Connectors (2) for the M3 Header and the M4 Header.
•
Connector for the M5 Motor Driver
•
Connector Solenoid SOL2.
•
Connector for Sensor S28.
•
Connectors (2) for Sensors S6-S10 and S11-S15.
4. Go to the front of the Punch
5. Tighten the M4 Screws (5) into the Front Frame.
6. Install the Die Lock Handle and tighten the M4 X 10 Phillips Head
Screw.
7. Install the Die Set (see Operation Instructions Manual).
8. Close the Front Door.
9. Do ARP 1.6 to install the Rear Cover.
10. Connect the Power Cord.
02-03-2017
4-83
Adjustments/Repairs