ARP 2.28.8 Backage Sensor Board (S16, S17) Replacement
Use this procedure to remove and install the Backage Sensor Board
(S16, S17) or the Backage Sensor Bracket.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
Backage Sensor Board
4. Disconnect the Sensor Board Connector at the Board.
5. Remove the Nuts (3), Washers (3), and the Backage Sensor Board.
GBC StreamPunch Ultra/Ultra MP
6. Place the new Backage Sensor Board in position.
7. Install the Washers (3) and tighten the Nuts (3)
8. Connect the Sensor Board Connector.
9. Do ARP 3.1 to install the Punch Module.
10. Do ARP 1.6 to install the Rear Cover.
11. Connect the Power Cord.
02-03-2017
4-73
Adjustments/Repairs