Arp 2.16 Idler Panel Mount Bracket Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.16 Idler Panel Mount Bracket Replacement
PARTS LIST ON PL 2.1
Use this procedure to remove and install the Idler Panel Mount Bracket.
Removal Procedure
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. There are 6 Idler Panel Mount Brackets in the machine (2 of them are
non-replaceble and marked with orange lacquer). Locate the
appropriate Idler Panel Mount Bracket.
Idler Panel Mount Bracket
NOTE: To remove the Entrance Drive Panel (ARP 2.1), you must only
remove the lower Idler Panel Mount Bracket.)
Adjustments/Repairs
4. Remove the Nuts (2) and the Idler Panel Mount Bracket.
Installation Procedure
1. Place the Idler Panel Mount Bracket in position and tighten the Nuts
(2).
2. Do ARP 1.6 to install the Rear Cover.
3. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-46