Arp 3.9 Steering Module Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.9 Steering Module Replacement

PARTS LIST ON PL 4.1
Use this procedure to remove and install the Steering Module Sub
Assembly.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Disconnect the Skew Sensor Board Connector.
GBC StreamPunch Ultra/Ultra MP
Skew Sensor Board Connector
5. Do the following to take the Alignment stepper belt off the pulley.
•
Loosen the Phillips Screws (2).
•
Remove the Alignment stepper Belt from the Pulley.
6. Pull the Alignment stepper belt in through the hole in the Frame.
02-03-2017
4-93
Screws (2)
Motor
Belt
Adjustments/Repairs