GBC StreamPunch Ultra Service Manual page 106

8. Remove the E-Ring (2) from each end of the Accel Idler Latch Shaft.
E-Ring E-Ring
9. Remove the Accel Idler Latch Shaft.
Shaft
10. Remove the Acceleration Idler Roller Assembly.
Adjustments/Repairs
Acceleration Idler Roller Assembly
11. To replace the Accel Idler Panel Weldment do the following
procedures to remove and install these components.
•
ARP 2.28.3 Accel Sensor (S5) Replacement
•
ARP 2.30.2 Disengaging Roller Solenoid Replacement
Installation Procedure
1. Place the Acceleration Idler Roller Assembly in position.
2. Slide the Accel Idler Latch Shaft through the holes in the frame and
the holes at each end of the Acceleration Idler Roller Assembly.
3. Install the E-Ring (2) at each end of the Accel Idler Latch Shaft.
4. Connect the Acceleration Idler Roller Solenoid SOL5 Connector at
the header.
5. Connect the Acccel Sensor S5 Connector.
6. Place the Cable in the cable Clamps and close the cable Clamps.
7. Grasp the Handle and close the Acceleration Idler Roller Panel.
8. Close the Front Door.
9. Do GP 6.4 Dock the Punch to connect the Punch to the upstream
and downstream devices.
10. Connect the Power cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-26