Arp 3.25 Punch Module Mount Pin Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.25 Punch Module Mount Pin Replacement
PARTS LIST ON PL 4.1
Use this procedure to remove and install the Punch Module Mount Pins.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Remove the Screw and the Mount Pin.
Mount Pin
5. Place the new Mount Pin in position and tighten the Screw.
6. Do ARP 3.1 to install the Punch Module.
7. Close the Front Door.
8. Do ARP 1.6 to install the Rear Cover.
9. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
Adjustments/Repairs 02-03-2017
4-122