ARP 2.9 Punch Lower Exit Panel Replacement
PARTS LIST ON PL 2.1
Use this procedure to remove and install the Lower Exit Panel
Removal Procedure
1. Disconnect the Power Cord.
2. Do GP 6.3 to undock the Punch from the upstream and downstream
equipment.
3. Do ARP 1.6 Rear Cover Replacement to remove the Rear Cover.
4. Do ARP 1.18 Downstream Docking plate removal
5. Do ARP 1.17 Drive roller cover removal to remove the downstream
side roller cover.
6. Open the Upper bypass panel.
7. Remove the Screws (2) from the Front Frame used to mount the
Lower Exit Panel.
8. Remove the Screws (2) from the Rear Frame used to mount the
Lower Exit Panel.
GBC StreamPunch Ultra/Ultra MP
9. Remove the Lower Exit Panel.
Installation Procedure
1. Place the Lower Exit Panel in position.
2. Tighten the Screws (4) used to mount the Inner Entrance Panel.
3. Do ARP 1.6 Rear Cover Replacement to install the Rear Cover.
4. Do ARP 1.18 to install Downstream Docking plate.
5. Do ARP 1.17 to install Drive roller cover.
6. Do GP 6.4 to dock the Punch to the upstream and downstream
equipment.
7. Connect the Power Cord.
8. Do ADJ 1.2 Diverter Solenoid adjustment.
02-03-2017
4-37
Adjustments/Repairs