Gp 6.1.7 Information Procedure - GBC StreamPunch Ultra Service Manual

GP 6.1.7 INFORMATION Procedure
Do the following to view information about: Die Type, Die cycles, Punch
Cycles, and Firmware
1. From the top level screen,
READY
SINGLE PUNCH
2. Press either the up arrow button or the down arrow button then press
the ENTER button to display the SETTINGS/ INFORMATION screen.
SETTINGS
INFORMATION
3. Press the down arrow button to move the return symbol down until it
is next to the word INFORMATION.
SETTINGS
INFORMATION
4. Press the ENTER button to display the DIE TYPE/DIE CYCLES
screen.
DIE TYPE
DIE CYCLES
See the following pages for
- Die Type Information
- Die Cycles Information
- Punch Cycles Information
- Firmware Information
GBC StreamPunch Ultra/Ultra MP
11-05-2018
6-15
General Procedures and Information