Adj 1.6 Dieset Recognition Board Adjustment - GBC StreamPunch Ultra Service Manual

ADJ 1.6 Dieset Recognition Board Adjustment

PARTS LIST ON PL 4.9
Use this procedure to adjust the Dieset Recognition Board.
1. Do ARP 1.6 to remove the Rear Cover.
2. Loosen the Screws (2) that hold the Dieset Recognition Reader
Board.
3. Insert a die set until the Dieset is about to contact the spring clips in
the Reader Board.
GBC StreamPunch Ultra/Ultra MP
4. Raise/ Lower the Reader Board so that the top most point of the
Reader Board is above the surface of the Dieset Recognition Board in
the Dieset.
It can be set so that the top of the clips are just under the top surface
of the recognition board. The spring clips will compress then the die
set slides over. If the reader is set too low, the reader will not contact
the recognition board. If the reader is set too high, there is a chance
of mis-read and damage to clips.
5. Tighten the Screws (2) that hold the Dieset Recognition Reader
Board.
6. Do ARP 1.6 to install the Rear Cover.
02-03-2017
4-145
Adjustments/Repairs