Arp 1.17 Drive Roller Cover Removal - GBC StreamPunch Ultra Service Manual

ARP 1.17 Drive roller cover removal
Use this procedure to remove the cover for Drive rollers on the entrance
side or exit side to get access to other parts.
Removal Procedure
1. Disconnect Power cord.
2. Do GP 6.3 to undock the Punch from upstream and downstream
equipment
3. Do ARP 1.6 Rear Cover Replacement to remove the Rear Cover.
4. For the entrance side, remove (2) M4 screws from the front frame.
5. Remove (2) M4 screws from the rear frame.
Adjustments/Repairs
Screws (2)
Screws (2)
6. Remove the Drive roller cover.
7. Use the same procedure for exit side drive roller cover by removing
the corresponding screws.
Installation Procedure
Reverse steps to re-install the cover.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-18