Arp 3.14 Steering Drive Roller Shaft Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.14 Steering Drive Roller Shaft Replacement
PARTS LIST ON PL 4.5
Use this procedure to remove and install the Steering Drive Roller Shaft.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Do ARP 3.9 to remove the Steering Module.
GBC StreamPunch Ultra/Ultra MP
5. Remove the E-Rings (2), the Spring, the Steering Drive Roller and the
Flat Washers (2) from each end of the Shaft.
6. Remove the Shaft from the Drive Panel Steering Sub Assembly.
02-03-2017
4-105
Adjustments/Repairs