ADJ 1.7 Idler Panel Magnetic Latches Adjustment
PARTS LIST ON PL 3.2, PL 3.4, PL 3.5
Two round spacer studs should contact the drive panels completely (GP
6.16). When the Idler assembly is latched there should not be any
movement in the assembly. If there is movement/play, do the below steps
to adjust the assembly.
ADJ 1.4.6 Procedure
This procedure applies to
•
Entrance Idler Panel (PL 3.2)
•
Exit Idler Panel (PL 3.4)
•
Upper Bypass Panel (PL 3.5)
1. Loosen the two screws that hold the magnet. With the panel closed
firmly, pull away the magnet away from the drive panel (to eliminate
the play in the magnet) and tighten both screws. The screws should
be tightened while the panel is closed firmly and the magnet pulled
away as shown.
Adjustments/Repairs
ADJ 1.4.7 Procedure
This procedure applies to
•
Lower Exit Panel Assembly (PL 2.1)
1. Loosen the two screws the hold the magnet. With the panel fully
closed (the panel will hit limiting tabs and you will hear a sound),
tighten the two screws.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-146