GBC StreamPunch Ultra Service Manual page 49

5. Check that the Steering Drive (Drive Panel Steering Sub Assembly)
and the Idler Panels should be centered to the guide brackets as
shown.
6. If one of the below panels is bent, Replace
• Steering idler panel weldment- PL 4.4; ARP 3.15
• Steering drive panel weldment- PL 4.5; ARP 3.17
• Alignment sensor bracket- PL 4.10; ARP 3.24
• Alignment sensor lower guide- PL 4.10; ARP 3.24
GBC StreamPunch Ultra/Ultra MP
11-05-2018
2-32
RTPS