Adj 1.8 Drive Panel Position Adjustment - GBC StreamPunch Ultra Service Manual

ADJ 1.8 Drive Panel Position Adjustment

PARTS LIST ON PL 2.2, PL 2.3, PL 3.1
Use this procedure to Inspect and adjust the Drive panel positions. The
drive panels control how far the drive rollers protrude into the paper path,
which in turn control the roller nip forces. All drive rollers should be
protruding 1.5±0.5mm through the paper path.
This procedure applies to
This drive panel controls the nip forces of N2, N3, N4 and N5.
GBC StreamPunch Ultra/Ultra MP
•
Entrance Drive Panel (PL 3.1)
•
Exit Drive Panel (PL 2.1)
•
Lower Bypass Panel (PL 2.1)
ADJ 1.4.8 ADJ 1.8.1 Entrance Drive Panel Position Adjustment
1. To adjust the position of the drive panel loosen (5) screws from the
Front frame and (5) screws from the rear frame.
2. Using the Reference holes in the front/rear frame (5 holes in the front
frame and 5 holes in the rear frame) and the sheet metal panel,
02-03-2017
4-147
Adjustments/Repairs