ARP 3.15
Steering Idler Panel Weldment Replacement
PARTS LIST ON PL 4.4
Use this procedure to remove and install a Steering Idler Panel
Weldment.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Unplug the Skew Senor and release the Cable Clamp.
GBC StreamPunch Ultra/Ultra MP
5. Remove the Screws (4) that hold the Steering Idler Panel Sub
Assembly to the Drive Panel Steering Sub Assembly.
6. Remove the Steering Idler Panel Sub Assembly.
7. Be sure not to lose the spacers on either end of the drive panel.
02-03-2017
4-107
Adjustments/Repairs