ARP 2.5 Entrance Drive Panel Assembly Replacement
PARTS LIST ON PL 2.1, PL 3.1
Use this procedure to remove and install the Entrance Drive Panel
Assembly.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
GBC StreamPunch Ultra/Ultra MP
3. Do ARP 3.1 to remove the Punch Module.
4. Do GP 6.3 Undock the Punch to separate the Punch from the
upstream and downstream devices.
5. Do ARP 1.15 to remove the Docking Bracket.
Docking Bracket
6. Do ARP 2.3 to remove the Entrance Idler Panel.
Entrance Idler Panel
(Cont.)
02-03-2017
4-27
Adjustments/Repairs