Arp 2.25.3 150T Belt Replacement; Arp 2.25.4 179T Belt Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.25.3 150T Belt Replacement

PARTS LIST ON PL 2.9
Use this procedure to remove and install the 150T Belt.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 2.24 to remove both of the Pulleys Connected to the Belt that
is being replaced.
4. Place the Belt in position between the Pulleys and slide the Pulleys
on to the Shafts.
5. Install the retaining rings
6. Do ARP 1.6 to install the Rear Cover.
7. Connect the Power Cord.
Adjustments/Repairs

ARP 2.25.4 179T Belt Replacement

PARTS LIST ON PL 2.9
Use this procedure to remove and install the Belt 179T, 2MM 2GT, 6MM
Wide.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Loosen the Tensioner and remove the old Belt.
4. Place the new Belt in position around the Pulleys.
5. Adjust the Belt Tension per ADJ 1.4 Timing Belt Adjustment.
6. Do ARP 1.6 to install the Rear Cover.
7. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-58