GBC StreamPunch Ultra Service Manual page 197

9. Remove the E-Ring from the Shaft at the rear of the Punch Module.
10. Remove the E-Ring from the Shaft at the front of the Punch Module.
11. Pull the Shaft out through the Cams (2) and out of the Punch Module.
Installation Procedure
1. Place a Die Lock Cam inside the Punch Module by the hole at the
front of the Punch Module (cam portion against side Frame).
2. Insert the Die Lock Shaft through the hole at the front of the Punch
Module and through the hole in the Cam.
GBC StreamPunch Ultra/Ultra MP
E-Ring
E-Ring
Shaft
02-03-2017
3. Push the Shaft through the Punch Module, through the hole in the
other Cam, and out through the hole in the rear of the front of the
Punch Module (cam portin against side Frame)
4. Insert the E-Ring on the Shaft at the front of the Punch Module.
5. Insert the E-Ring on the Shaft at the rear of the Punch Module.
6. Insert the Socket Head Cap Screw and Split Lock Washer into the
Cam and the Shaft at the front of the Punch Module.
7. Insert the Phillips Screw into the Cam and the Shaft at the rear of the
Punch Module.
8. Insert the Shoulder Screw the hole in the Shaft at the rear of the
Punch Module. Make sure it is in the correct phase (Shoulder Screw
facing down as well as Cam Screws facing down).
9. Do ARP 3.1 to install the Punch Module.
10. Insert the Die Lock Handle into the Shaft at the front of the Punch
Module, and tighten the Screw.
11. Do ARP 1.6 to install the Rear Cover.
12. Connect the Power Cord.
4-117
Adjustments/Repairs