Arp 3.7 Clutch Or Clutch Pulley Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.7 Clutch or Clutch Pulley Replacement

PARTS LIST ON PL 4.8
Use this procedure to remove and install the Clutch or the Clutch Pulley in
the Punch Module.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1.1 Punch Module Removal.
4. Do ARP 3.6 to remove the Punch Motor Belt.
5. To remove the Clutch Pulley
•
Remove the M5X18 Screws (3) and Split Lock Washer (3)
•
Remove the Pulley and Flange.
6. Remove the Lock Nut and the long M6 Screw.
GBC StreamPunch Ultra/Ultra MP
Screws
Pulley and Flange
(Cont.)
7. Loosen the Set Screws (2) from the Clutch.
You can press down on the actuator and turn the punch shaft to
orient the set screw in any direction for easy access.
02-03-2017
4-89
Lock Nut (2)
Screw
Set Screws (2)
Clutch
Adjustments/Repairs