GBC StreamPunch Ultra Service Manual page 331

Acceleration Idler Latch Inspection
To inspect the Acceleration Idler latch follow the below procedure:
1. Open the Front door.
2. Undock StreamPunch Ultra/Ultra MP.
3. When the Acceleration panel latch is fully engaged, the tabs in the
Idler panel should contact the drive panel. Inspect this for the latches
in the front side and rear side.
GBC StreamPunch Ultra/Ultra MP
4. Do ARP 3.1.1 Punch Module Removal to remove the Punch Module.
5. Inspect the Acceleration Idler Panel latch assembly (front and rear
side). There should be two springs between the latch mechanism and
the Entrance Drive panel.
6. If the springs are damaged, do ARP 2.17 Accel Idler Panel Rear
Latch Assembly Replacement or ARP 2.17 Accel Idler Panel Front
Latch Assembly Replacement.
11-05-2018
6-57
Acceleration panel latch springs
General Procedures and Information