7. Disconnect the Left/Right Steering Stepper Connectors at the Punch
Frame. One of the Connectors has 6 pins the other has 7 pins.
•
Push the connector towards the outside of the frame.
•
Press down on the top tab to remove it from the top side. Then
press the bottom tab to release the connector fully.
8. Release the Cable Clamp
Adjustments/Repairs
9. Similarly remove the Alignment home sensor connector.
10. Remove the Phillips Screws (8)- (4) from front side and (4) from rear
side
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-94
Screws (8)