Arp 2.28.7 Alignment Sensor Board (S11 - S15) Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.28.7 Alignment Sensor Board (S11 – S15) Replacement
Use this procedure to remove and install the Alignment Sensor Board
(S11, S12, S13, S4, S15).
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Disconnect the Skew Sensor Board Connector.
5. Release the Cable Clamp and move the Cable out of the way.
6. Remove the M4 Nuts (2) and remove the steering idler roller cover.
GBC StreamPunch Ultra/Ultra MP
Skew Sensor Board Connector
7. Remove the sleeve from the threaded stud.
8. Disconnect the Alignment sensor board connector.
9. Release the Cable Clamp and move the Cable out of the way.
10. Remove the M4 Nuts (2) and Washers (2),
11. Remove the Alignment Sensor Board.
02-03-2017
4-71
M4 nuts (2)
Washers (2)
Adjustments/Repairs