Arp 2.26.1 Drive Roller N5 Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.26.1 Drive Roller N5 Replacement

Do the following to remove and replace the Drive Roller for Nip N5.
Removal Procedure
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Loosen the nuts (2) on the Tensioner of the M2 motor belt.
5. Remove the retaining ring from the shaft of roller N5.
GBC StreamPunch Ultra/Ultra MP
Tensioner
Nuts (2)
6. Remove the Belt from the Motor Pulley
7. Slide the Pulley off the Roller Shaft.
(Cont.)
02-03-2017
4-61
Adjustments/Repairs