GBC StreamPunch Ultra Service Manual page 175

11. Remove the Steering Module from the Punch Module, by tilting the
Steering Module as shown. This is to ensure the back side clears the
self-clinching nut.
GBC StreamPunch Ultra/Ultra MP
Installation Procedure
1. Place the Steering Module into the Punch Module.
2. Push the Steering Belt out through the hole in the Frame.
3. Install the Phillips Screws (8).
4. Connect the Align Home Sensor and the Left/Right Steering Motor
Connectors.
5. Place the Alignment Stepper motor Belt around the Pulley.
6. Tighten the Phillips Screws (2).
7. Do ARP 3.1 to install the Punch Module.
8. Close the Front Door.
9. Do ARP 1.6 to install the Rear Cover.
10. Connect the Power Cord.
02-03-2017
4-95
Steering Module
Adjustments/Repairs