Arp 2.22 One Way Clutch And Pulley Sub-Assembly Replacement4-54; Arp 2.23 Drive Idler Roller Assembly Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.22 One Way Clutch and Pulley Sub-Assembly Replacement
PARTS LIST ON PL 2.4
Use this procedure to remove and install the One Way Clutch and Pulley
Sub-Assembly.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Remove the E-Clip and Washer.
3. Slide the old One Way Clutch Assembly off the Shaft, while leaving
the Timing Belt in place.
4. Place the new One Way Clutch Assembly on to the Shaft.
5. Install the Washer and the E-Clip.
6. Connect the Power Cord.
Adjustments/Repairs
ARP 2.23
PARTS LIST ON PL 2.3
Use this procedure to remove and install a one way Drive Idler Roller
Assembly.
Removal Procedure
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 2.25.1 to remove the 534T Belt
3. Remove the E-ring and the Spacer.
4. Slide out the old Idler Roller from the Stud.
One Way Clutch
E-Clip and
Washer
5. Place the new Idler Roller on the Stud.
6. Install the Spacer and the E-ring.
7. Do ARP 2.25.1 to install the 534T Belt
8. Connect the Power Cord.
02-03-2017
Drive Idler Roller Assembly Replacement
WARNING
GBC StreamPunch Ultra/Ultra MP
4-54
Stud
Idler Roller