Gp 6.26 Die Set Recognition Board Clips Inspection - GBC StreamPunch Ultra Service Manual

GP 6.26 Die Set Recognition Board Clips Inspection

Use this procedure to Inspect and clean the Die Set recognition board
clips every 1000K cycles.
1. Press the Power Switch to the off position.
2. Disconnect the Power Cord.
3. Do ARP 1.6 to remove the Rear Cover.
4. Inspect the Die Set Recognition reader spring clips to check if they
are bent. When a die set is inserted, the spring clips should deform
and fully contact the Die Set Recognition Board in the Die Set .
5. Wipe the spring clips with a clean cloth.
6. Do ARP1.6 to install rear cover
GBC StreamPunch Ultra/Ultra MP
GP 6.27 Die Lock Mechanism and Die Rail Springs Inspection
Use this procedure to inspect the Die lock mechanism every 1000K
cycles
1. Press the Power Switch to the off position.
2. Disconnect the Power Cord.
3. Do ARP 1.6 to remove the Rear Cover.
4. Do ARP 3.1.1 to remove the Punch Module.
5. Raise the die lock plunger by hand to inspect if there is a heavy
spring force. There is an internal spring in the mechanism that
provides the locking load. The load is quite heavy and the plunger
may not move up. This is normal and can be verified again during
Step 10.
6. Inspect (4) plastic bushings in the Die lock brackets. (2) in the front
and (2) in the back.
11-05-2018
6-67
General Procedures and Information