Arp 2.3 Entrance Idler Panel Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.3 Entrance Idler Panel Replacement

PARTS LIST ON PL 2.2, PL 3.2
Use this procedure to remove and install the Entrance Idler Panel.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Open the Front Door.
3. Do GP 6.3 Undock the Punch to separate the Punch from the
upstream and downstream devices.
4. Do ARP 1.15 to remove the Docking Bracket.
Docking Bracket
5. Open the Cable Clamps to release all the sensor cables.
Adjustments/Repairs
6. Disconnect the Connectors for Sensors S2, S3, & S4.
7. Remove the screw for ground strap
8. Disconnect the Connectors for Solenoids SOL3 & SOL4 from the
header.
Solenoid SOL3 &
SOL4 Connectors
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-22
Sensor S2, S3, & S4 Connectors