Arp 2.25 Timing Belt Replacement; Arp 2.25.1 534T Belt Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.25 Timing Belt Replacement
There are eight (8) belts used at the rear of the Frame in the
StreamPunch Ultra/Ultra MP.
Fie (5) belts connect to motors.
Type of Belt #
Belt, 534T, 2MM 2GT 1 belt
Belt, 134T, 2MM 2GT 3 belts
Belt, 179T, 2MM 2GT, 1 belt
6MM Wide
Three (3) belts are used to connect two nip rollers.
Type of Belt #
Belt, 150 T, 2MM 2GT 3 belts
Use the following procedures to Replace the belts.
Adjustments/Repairs
Motor ARP Page
M8 ARP 2.25.1 4-56
M1 ARP 2.25.2 4-57
M6
M7
M2 ARP 2.25.4 4-58
Connects ARP Page
Rollers
N1 and N2 ARP 2.25.3 4-58
N2 and N3
N8 and N9

ARP 2.25.1 534T Belt Replacement

PARTS LIST ON PL 2.9
Use this procedure to remove and install the 534T Belt for the Bypass
Motor (M8).
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Loosen the Tensioner and remove the old Belt.
4. Place the new Belt in position around the Pulleys (11).
(Cont.)
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-56
Tensioner