Arp 2.4 Acceleration Roller Idler Assembly Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.4 Acceleration Roller Idler Assembly Replacement

PARTS LIST ON PL 3.1, PL 3.3
Do the following to replace the Acceleration Idler Roller Assembly (or the
Accel Idler Panel Weldment).
Removal Procedure
1. Disconnect the Power Cord.
2. Do GP 6.3 Undock the Punch to separate the Punch from the
upstream and downstream devices.
3. Open the Front Door.
GBC StreamPunch Ultra/Ultra MP
Acceleration Idler panel Handle
4. Open the Acceleration Idler Roller Panel and remove the M4 screw
for ground strap.
5. Open the Cable Clamps to release the Sensor Cable.
Cable
Clamps
Sensor S5
Connector
6. Disconnect the Accel Sensor S5 Connector at the the sensor
7. Disconnect the Acceleration Idler Roller Solenoid SOL5 Connector at
the rear frame.
(Cont.)
02-03-2017
4-25
Solenoid SOL5
Connector
Adjustments/Repairs