Gp 6.21 Timing Belt Inspection - GBC StreamPunch Ultra Service Manual

GP 6.21 Timing Belt Inspection

There are 11 belts used in the StreamPunch Ultra/Ultra MP.
Assembly
Punch Module 1 belt
Steering Module 1 belt
Drive Panel Steering 2 belts
Sub Assembly
Frame 8 belts
Five of the belts at the rear of the Frame have Tensioner Assemblies. It is
these five belts that should be checked.
Maintenance Schedule
Inspect the Timing Belt every 1000K cycles.
Procedure
Do the following to inspect the Timing Belts.
1. Inspect all timing belts for wear, missing teeth, frayed edges, and
cracks.
2. For replacement, see ARP 2.2Timing Belt Replacement
3. Check for proper deflection of belts.
The belts should be slightly loose with approximately 1/4" deflection
[1].
Belts that are too loose will not drive properly and belts that are too
tight can wear out prematurely or damage their driven components.
GBC StreamPunch Ultra/Ultra MP
# of Belts
11-05-2018
6-63
General Procedures and Information