Arp 3.19 Punch Shaft Ball Bearing Replacement; Arp 3.20 Die Stop Magnet Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.19 Punch shaft Ball Bearing Replacement
PARTS LIST ON PL 4.1
Use this procedure to remove and install the Ball Bearing on the punch
shaft
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Remove the E-Ring.
4. Remove the Nylon Washer.
5. Remove the Ball Bearing.
6. Place the new Ball Bearing in position.
7. Place the Nylon Washer in position.
8. Place the E-Ring in position.
9. Do ARP 1.6 to install the Rear Cover.
10. Connect the Power Cord.
Adjustments/Repairs
ARP 3.20
PARTS LIST ON PL 4.1
Use this procedure to remove and install the Die Set Magnet.
1. Disconnect the Power Cord.
2. Loosen the Nut and Lock Screw.
3. Rotate the Die Set Magnet counterclockwise and remove it from the
Shaft.
Ball Bearing
Nylon Washer
E-Ring
4. Place the new Die Set Magnet on the Shaft and rotate it clockwise.
5. Do ADJ 1.3 Die Stop Magnet Adjustment
6. Connect the Power Cord.
02-03-2017
4-114
Die Stop Magnet Replacement
GBC StreamPunch Ultra/Ultra MP