Installation Procedure
1. Place the Accel Panel Rear and Front Latch Assemblies in position to
install the Accel Idler Latch Shaft.
2. For the Accel Idler Panel Front Latch Assembly, slide the shaft
towards the front side to install.
3. For the Accel Idler Panel Rear Latch Assembly, slide the shaft
towards the rear side to install.
4. Install the E-clip on the Accel Idler Shaft from the front side.
5. Do ARP 2.20 to install the Accel Idler Latch Handle.
6. Install the E-clip on the Accel Idler Shaft from the rear side.
7. Install the M3 screws (2) in the Accel Idler Panel Front and Rear
Latches.
8. Hook the Extension Springs to the Accel Idler Panel Front and Rear
Latches.
9. Do ARP 3.1.2 to install the Punch Module.
10. Do ARP 1.6 to install the Rear Cover.
11. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-53
Adjustments/Repairs