ARP 2.18
Snap-in Bearing Replacement
PARTS LIST ON PL 2.2, 2.3, 3.2, 3.3, 3.5, 3.4
Use this procedure to remove and install a Snap-in Bearing, located in
one of the following assemblies.
•
Entrance Idler Panel (PL 3.2)
•
Acceleration Roller Idler Assembly (PL 3.3)
•
Upper Bypass Panel (PL 3.5)
•
Exit Idler Panel (PL 3.4)
•
Lower Exit Panel (PL 2.2)
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do one of the following to remove the panel so you can access the
Snap-in Bearing.
•
ARP 2.3
Entrance Idler Panel Replacement
•
ARP 2.5
Acceleration Roller Idler Assembly Replacement
•
ARP 2.7
Upper Bypass Panel Replacement
•
ARP 2.9
Exit Idler Panel Replacement
•
ARP 2.13 Lower Exit Panel Replacement
Adjustments/Repairs
3. Remove the Snap-in Bearing.
4. Place the new Snap-in Bearing in position.
5. Do one of the following to install the panel.
•
ARP 2.3
Entrance Idler Panel Replacement
•
ARP 2.5
Acceleration Roller Idler Assembly Replacement
•
ARP 2.7
Upper Bypass Panel Replacement
•
ARP 2.9
Exit Idler Panel Replacement
•
ARP 2.13 Lower Exit Panel Replacement
6. Connect the Power Cord.
7. Press the Power Switch to the on position.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-48