Gp 6.23 Alignment Carriage Rails Cleaning; Gp 6.24 Punch Clutch Inspection And Cleaning - GBC StreamPunch Ultra Service Manual

GP 6.23 Alignment Carriage Rails Cleaning

Do this procedure to clean the Alignment Carriage Rails.
Preventative Maintenance:
Do this every 500K cycles.
Procedure
1. Do ARP 3.1.1 to remove the Punch Module
1. Use a can of compressed air to remove dust from the alignment
carriage rails. The carriage can be moved back and forth on the rails
to clean the entire surface. Alternately, a soft cloth and alcohol can be
used.
Important Note: DO NOT use any lubricant on the rail.
2. Once the rails are cleaned, check the motion of Alignment carriage on
the rails. It should move when a force less than 2kgf is applied. If
there is binding in the rails, replace the Alignment Carriage sub-
assembly.
3. Do ARP 3.1.2 to install the Punch Module.
GBC StreamPunch Ultra/Ultra MP

GP 6.24 Punch Clutch Inspection and Cleaning

Use this procedure to inspect and clean the punch clutch every 1000K
cycles.
If the Punch Module is removed from the machine for servicing other
components, do all steps. Otherwise do all steps except step 9.
4. Disconnect the Power Cord.
5. Do ARP 1.6 to remove the Rear Cover.
6. With a cloth wipe the collar of the clutch and remove any oil from the
surface.
7. Inspect the collar stop and the metal insert pawl for any wear.
11-05-2018
6-65
General Procedures and Information