Leveling & Height Adjustment; Height Setting; Adjusting The Casters - GBC StreamPunch Ultra Service Manual

8.7. Leveling & Height Adjustment
8.7.1

Height Setting

No height adjustment of the StreamPunch Ultra/MP is required for an
installation site with a level floor. If the floor is uneven then it is
recommended to set the level of the StreamPunch Ultra/MP using the
upstream device as a reference. . If the StreamPunch Ultra/MP is
connected downstream of a printer with a decurler installed then the
documentation supplied with the decurler should be referred to set the
decurler exit height. After setting the height check the exit guide of the
StreamPunch Ultra/MP is set as shown below for the various finisher
types.
Downstream
Device Input
Finisher Reference Height X
SR5050; SR5060; 3mm
SR4080; SR4110
SK50**
series
Installation Instructions
StreamPunch Ultra
Output
X
Y
Finisher Reference Height Y
SK50** series 2.5mm
8.7.2

Adjusting the Casters

a) Using a 19mm (3/4") open ended wrench, loosen the jam nut(s)
situated on the caster stud under the base of the machine.
b) Using the 17mm (11/16") wrench, rotate the caster stems to change
the height.
Re-tighten the jam nuts once the correct height is achieved.
02-03-2017
8-8
GBC StreamPunch Ultra/Ultra MP