Arp 3.5 Punch Motor Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.5 Punch Motor Replacement

PARTS LIST ON PL 4.11
Use this procedure to remove and install the Punch Motor (M10).
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Do ARP 3.6 Punch Motor Belt Replacement (Timing Belt) to remove
the Punch Motor Belt.
Adjustments/Repairs
5. Remove the M8 Hex Cap Screws (4), the M8 Split Lock Washers (4),
6. Remove the old Punch Motor.
Installation Procedure
Punch Motor 1. Using the position marks on the Bracket, place the new Punch Motor
Belt
2. Place the Flat Washers (4) and the M8 Split Lock Washers (4) in
3. Tighten the M8 Hex Cap Screws (4).
4. Do ARP 3.6 Punch Motor Belt Replacement (Timing Belt) to install the
5. Do ARP 3.1 to install the Punch Module.
6. Do ARP 1.6 to install the Rear Cover.
7. Connect the Power Cord.
and the Flat Washers (4).
in position.
position.
Punch Motor Belt.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-86
Cap Screws (4),
Split Lock Washers (4),
Flat Washers (4)
Mark