8.5. Docking Bracket Installation
The docking brackets are shipped in a separate bag along with size M4
mounting screws (not shown).
The screws are 6mm long.
Important Note: If installing punch unit directly downstream to a printer
that utilizes a decurl unit, docking bracket D434-1476 must be used to
complete installation. Part is available through standard parts channel.
Install the supplied docking brackets as shown with the bracket marked
"R" on the right side facing you as you look at the exit side of the
upstream device. Install the bracket marked "L" on the left side facing
you. Both brackets should be oriented with the arrow facing up.
If there is already a docking bracket on the upstream device, it needs to
be
removed
as
it
will
GBC StreamPunch Ultra/Ultra MP
be
used
in
the
next
Before the system can be docked correctly the paper guide on the
finisher needs to be removed. This is not used on the finisher when in
line with the StreamPunch Ultra/MP.
The docking bracket(s) provided with StreamPunch Ultra/MP's upstream
device should be attached to the downstream side of the StreamPunch
Ultra/MP with (4) size M4 screws.
step.
02-03-2017
8-5
Installation Instructions