6. Remove Screws (2) from the diverter solenoid sub assembly.
7. Remove the Diverter Solenoid Sub-assembly.
Installation Procedure
1. Place the new Solenoid in position and tighten the Screws (2) to the
rear frame and two screws to the diverter shaft
2. Connect the inline Connector for the Diverter Solenoid.
Adjustments/Repairs
3. Place the the Cable into the Cable Clamps and close the Cable
Clamps
4. Do ADJ 1.2 Diverter solenoid adjustment.
5. Do ARP 1.16 to install the Exhaust Fan Bracket
6. Do ARP 1.6 to install the Rear Cover.
7. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-76