Service User Interface
The Service User Interface allows you to:
•
Set the Paper Size, Max Bypass sheet length and Run Mode.
•
Check the operation of the Sensors, Solenoids, and the Motors.
•
Run the Cycle Punch, Aligner Test, Exhaust fan test routines.
•
Set the Skew Offsets and Align Offsets.
•
View Die cycles and Machine log
•
Upgrade Firmware
When the Service user Interface is open, the top row of text and the
bottom row of text display the options on the Service User Interface
menu.
General Procedures and Information
Paper Size
The Paper Size feature allows you to select the desired paper size.
•
ANSI
•
ISO
Max Bypass
The Max Bypass feature allows you to set the maximum sheet length that
will be bypassed through StreamPunch Ultra/Ultra MP.
Run Mode
The Run Mode feature allows you to select the desired run mode.
•
AUTO RUN
AUTO CYCLE
•
Sensors
The Sensors feature allows you to view the state of each of the 29
sensors to the StreamPunch Ultra/Ultra MP.
•
0 means the sensor is open.
•
1 means the sensor is covered
Press the Up Arrow button and Down Arrow buttons to scroll through the
list of sensors.
Solenoids
The Solenoid feature allows you to test the operation of each of the 8
solenoids to the StreamPunch Ultra/Ultra MP.
Press the Up Arrow button and Down Arrow buttons to scroll through the
list of solenoids.
GBC StreamPunch Ultra/Ultra MP
11-05-2018
6-20