Arp 3.16 Steering Idler Roller Assembly Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.16 Steering Idler Roller Assembly Replacement
PARTS LIST ON PL 4.4
Use this procedure to remove and install a Steering Idler Roller Assembly.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Disconnect the Skew Sensor Board Connector.
GBC StreamPunch Ultra/Ultra MP
5. Release the Cable Clamp and move the Cable out of the way.
6. Remove the M4 Nuts (2).
7. Remove the Roller Cover.
8. Gently move the Springs (2) off the ends of the Roller.
02-03-2017
4-109
Adjustments/Repairs