Adj 1.2 Diverter Solenoid Adjustment - GBC StreamPunch Ultra Service Manual

ADJ 1.2 Diverter Solenoid Adjustment

PARTS LIST ON PL 2.3
Use this procedure to adjust the position of the Diverter Solenoid
Assembly.
1. Open the Front Door.
2. Do ARP 1.6 to remove the Rear Cover.
3. With the Interlock cheater inserted, do GP 6.2.6 to actuate SOL1
(L1-Diverter Solenoid). This will switch the diverter gate to punch
mode. The Diverter gate will rise and hit the upper bypass panel.
4. When the solenoid in not actuated, it needs to rest on the Diverter
limiter bracket. To properly adjust the position of the limiter bracket do
the following:
GBC StreamPunch Ultra/Ultra MP
a. Loosen the Screws (2) that hold the Limiter Bracket.
b. Insert a 0.25 to 0.5mm shim between the Diverter and the Lower
Entrance Panel.
02-03-2017
4-133
Shim (0.25 to 0.5mm)
Adjustments/Repairs