Arp 2.28.6 Skew Sensor Board (S6 - S10) Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.28.6 Skew Sensor Board (S6 – S10) Replacement
Use this procedure to remove and install the Skew Sensor Board (S6, S7,
S8, S9, S10).
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
Skew Sensor Board
4. Disconnect the Skew Sensor Board Connector.
Skew Sensor Board
Adjustments/Repairs
Skew Sensor Board Connector
5. Remove the Nuts (4), Washers (4), and the Skew Sensor Board. (do
not remove the washers under the sensor board)
6. Place the new Skew Sensor Board in position.
7. Install the Washers (4) and tighten the Nuts (4). (Make sure there are
(4) washers below the sensor board).
8. Connect the Sensor Board Connector.
9. Do ARP 3.1 to install the Punch Module.
10. Do ARP 1.6 to install the Rear Cover.
11. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-70
Skew Sensor Board