Arp 3.3 Chip Level Emitter Replacement; Arp 3.4 Chip Level Receiver Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.3 Chip Level Emitter Replacement

PARTS LIST ON PL 2.5
Use this procedure to remove and install the Chip Level Emitter
Assembly.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Open the Front Door.
3. Remove the Chip Tray.
4. Locate the Chip Level Emitter on the Frame at the left (downstream)
side of the Chip Tray compartment.
5. Disconnect Cable 7715485 at the Chip Level Emitter.
Chip Level Emitter
Screws (2)
6. Remove the Screws (2) and the old Chip Level Emitter.
There will be Washers (4) between the Sensor and the sheet metal
Bracket.
7. Place the new Chip Level Emitter, and the Washers (4), in position
and tighten the Screws (2).
8. Connect Cable 7715485 at the Chip Level Emitter.
9. Put the Chip Tray in position and push the Chip Tray Assembly in
firmly until it latches.
10. Close the Front Door.
11. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
Cable 7715485
02-03-2017

ARP 3.4 Chip Level Receiver Replacement

PARTS LIST ON PL 2.5
Use this procedure to remove and install the Chip Level Receiver
Assembly.
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Open the Front Door.
3. Remove the Chip Tray.
4. Locate the Chip Level Receiver on the Frame at the right (upstream)
side of the Chip Tray compartment.
5. Disconnect Cable 7715485 at the Chip Level Receiver.
6. Remove the Screws (2) and the old Chip Level Receiver.
There will be Washers (4) between the Sensor and the sheet metal
Bracket.
7. Place the new Chip Level Receiver, and the Washers (4), in position
and tighten the Screws (2).
8. Connect Cable 7715485 at the Chip Level Receiver.
9. Put the Chip Tray in position and push the Chip Tray Assembly in
firmly until it latches.
10. Close the Front Door.
11. Connect the Power Cord.
4-85
WARNING
Screws (2)
Chip Level Receiver
Cable 7715485
Adjustments/Repairs