GBC StreamPunch Ultra Service Manual page 209

Installation Procedure
1. Install the the Comm Board on the Main Control Board using the plug-
in connector.
2. Place the new Main Control Board and Comm Board in position
3. Press the Control boards on the plasctic standoffs so that it snaps in
place (13).
4. Tighten the M3 Screw in the Main Control Board.
5. Connect the Connectors (29).
Refer to the Section 7 Wiring.
The following table lists the connectors starting at the top right and
going counterclockwise.
Cable/Wire #
7715523 J36
7715455 J23
7715467 J19
7715466 J18
7715536 J29
7715451 J21
7715485 J27
7715477 J17
7715473 J15
7715453 J22
7715495 J9
7715468 J14
7715457 J25
7715456 J24
7715476 J2
7715493 J3
7715494 J4
7715487 J8
7715492 J1
GBC StreamPunch Ultra/Ultra MP
Connector #
Cable/Wire #
7715459
7715458
7715267
7715470
775538
7715490
7715537
7715494
7715498
7715726
6. Do ARP 1.6 to install the Rear Cover.
7. Connect the Power Cord.
02-03-2017
4-129
Connector #
J28
J26
J20
J16
J37
USB Connector
J12
J15 COMM Board
J14 COMM Board
J16 COMM Board
Adjustments/Repairs