Gp 6.14 Idler Roller And Idler Springs Inspection - GBC StreamPunch Ultra Service Manual

GP 6.14 Idler Roller and Idler Springs Inspection

Idler rollers press against the drive rollers and move the paper through
the bypass [1] or the punch [2].
Maintenance Schedule
Inspect and clean every 1000K cycles.
Procedure
1. For the Idler Rollers in the following nips, inspect the rollers for wear,
debris, toner marks, unevenness, and dents.
N1 N9
N2 N10
N3 N11
N4 N12
N5 N13
N8 N14
2. Inspect Springs (2) for each Idler Roller, and make sure they are
correctly hooked.
Idler Roller Shaft Idler Roller
Retaining Spring
3. Inspect the Bearing Housing. The Bearing Housing should slide freely
in the Bearing Forks.
General Procedures and Information
Bearing Housing
GBC StreamPunch Ultra/Ultra MP
11-05-2018
6-52