Punch Module; Arp 3.1 Punch Module Replacement; Arp 3.1.1 Punch Module Removal - GBC StreamPunch Ultra Service Manual

3. Punch Module

ARP 3.1 Punch Module Replacement

PARTS LIST ON PL 4.1
Use this procedure to remove and install the Punch Module.
ARP 3.1.1 Punch Module Removal
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Open the Front Door.
4. If a die set is installed, remove it and store it in the die storage rack.
GBC StreamPunch Ultra/Ultra MP
5. Use the levers (blue) to open the Acceleration Roller Idler Panel and
the Exit panel.
6. Remove the M4 X 10 Phillips Head Screw and the Die Lock Handle.
02-03-2017
4-79
Adjustments/Repairs