Arp 2.8 Drive Exit Panel Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.8 Drive Exit Panel Replacement

PARTS LIST ON PL 2.1
Use this procedure to remove and install the Drive Exit Panel.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do GP 6.3 to undock the Punch from the upstream and downstream
equipment.
3. Do ARP 1.18 Downstream Docking plate removal
4. Do ARP 2.6 to remove the Lower Exit Panel.
5. Do ARP 2.7 to remove the Exit Idler Panel.
6. Remove (3) M4 nuts to remove the Bracket in Area 5 of the machine.
7. Do ARP 2.27 to remove Motor M7 by removing (4) screws.
GBC StreamPunch Ultra/Ultra MP
8. Remove the Timing Belt Tensioner Assembly of Motor M6 by
removing (2) nuts.
9. Remove (5) screws from the front frame that mount the Exit drive
panel.
02-03-2017
4-35
Adjustments/Repairs