GBC StreamPunch Ultra Service Manual page 171

10. To replace the Clutch Pulley
•
Place the Pulley and Flange in position.
•
Tighten the M5X18 Screws (3) with the Split Lock Washers (3).
11. Place the Punch Shaft Bearing Bracket in position and tighten the
Screws (2).
12. Do ARP 3.6 to install the Punch Motor Belt.
13. Do ARP 3.19 Ball Bearing Replacement to install the Ball Bearing.
14. Do ADJ 1.5 Punch Cam Indexing.
15. Do ARP 3.1.2 Punch Module Installation.
16. Do ARP 1.6 to install the Rear Cover.
17. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-91
Adjustments/Repairs