Final Steps; Printer & Finisher Firmware; Enabling The Punch Icon; Streampunch Ultra Mp Settings - GBC StreamPunch Ultra Service Manual

8.8. Final Steps

8.8.1 Printer & Finisher Firmware
Confirm that the printer and finisher have the latest firmware installed.
Firmware is available for download at
www.my-ricoh.com (EU) or can be obtained by contacting Ricoh service.
8.8.2

Enabling the Punch Icon

If the punch icon (shown below) for the Stream Punch Ultra option does
not appear on the operation panel, follow the procedure below:
a) Shut down the printer.
b) Turn OFF of the main power switch located inside the front door of the
printer
c) Wait for at least 10 seconds
d) Turn ON the main power switch.
e) Punch icon will appear on the printer screen.
8.8.3

StreamPunch Ultra MP settings

In the StreamPunch Ultra MP LCD go to SETTINGS> PRINTER and
select either CHARIS or MARTINI per the table below. This menu will not
appear for StreamPunch Ultra.
Printer
MP 6503
MP 7503
MP 9003
MP C6503
MP C8003
Note: This setting is not required when in
Columbia mode see Section 6.b) or with
StreamPunch Ultra
GBC StreamPunch Ultra/Ultra MP
www.myricoh.com (US) or
Punch Icon
Setting
MARTINI
CHARIS
8.8.4

Functional Test

Functional test the StreamPunch Ultra/ MP system
a) Check to ensure that the paper chip tray is securely in place.
b) Check to ensure that a die set is installed properly and that any extra
die sets are securely stored in the die storage area.
c) Run a small test job in "Bypass" mode. Check to ensure that the job is
not punched and bypasses properly.
d) Run a small job with punch enabled. Check the punched holes of the
job.
e) Run each die set to punch 100 sheets or until there is no oil residue
around the holes.
8.8.5

User manual

Print a copy of StreamPunch Ultra/MP User manual from the supplier CD
and leave it at the install location.
02-03-2017
8-9
Installation Instructions